Description: The article is mainly designed to focus on the topic of netgear login. The author is going to show you the detailed simple steps on how to set up or configure your neck a wireless Netgear Rooter, then you learn how to configure your modem to enable Wi-Fi Congrats.
This is praveen for techempty, today I’ll be showing you how to set up or configure your neck a wireless Rooter, this was divided into three simple steps.
The first one is setting up your net K Rooter to PC, the second one is how to get nakey Rooter login page to configure rate and the third one is resetting your neck a Rooter password.
So let’s get started. The first one is setting up your neck a Rooter to PC, take your Rooter and power it up using adaptive supplied with retail package, connect the ISP cable to colour port, take the LAN cable and connect it to any one of the LAN port.
The other end of the cable should be connected to PC land input in case if you need to configure your net gear Rooter with a modem, then follow this method, this practice helps you to auto dial up your network.
For example, in this case, BSNL network take your modem and input your isp two lines port of modem, take a LAN cable and connect it to your modem, the other end of the LAN cable should be connected to coloured port of Ruta as input, get another LAN cable and input the same two Rooter LAN port and PC LAN port.
In this case, you need to configure both modem and router separately refer this tutorial on how to configure your modem to enable Wi-Fi Congrats, your first step is now completed,
The second is getting login page of Netgear router and the configuration part, turn your router to find the login IP address of Netgear router, if you are not able to find it, try the following IP addresses, make sure to power up your Ruta before implementing these steps.
If you get the login page, enter the default values like username as admin and password is password or one-two-three-four, if you are not able to get the neck edge router login page with these IP addresses of faith to login with default login credentials.
Then follow the method to reset the router which I’ll be showing you in the next few minutes, hope you can get the admin panel of the router here, go to wireless settings tab and select enable SSID broadcast, name your SSID region and select wpa2 PSK in security options.
Then enter the password that you would like to use to connect with wireless network, you have successfully configured the netgear wireless route, a third step to know how to reset net kill wireless to top, turn your Rooter to the back and next to your antenna, there will be a small pin switch, take a pen or pencil and press this switch for about 10 seconds.
Wait a few minutes and try login with the previous IP addresses and credentials, hope you find this tutorial useful, if you need more tutorials related to this topic, please do let us know, if you face any issues, do comment below, do a share or thumb up this video, if you think it is worth sharing, please don’t forget to subscribe to our channel for more tutorials, your contribution is more to us, thanks.